on the oscilloscope. This enables the internal serial port for flashing.
: For newer revisions, try holding down the Power button while the device is off. The device may enter a boot loop that enables the serial port or USB mode. 2. Driver Setup (Windows) Connect the DSO to your PC while in FEL mode. Open Zadig . dso2512g firmware install
on the scope. Do not release it until the entire process is finished. The device may appear to power cycle, which is normal. Identify Port : Note the new assigned to the device in Windows Device Manager. Flash the Device Select the correct COM port in the upgrade tool. Open Serial (or similar button) followed by on the oscilloscope
: Use a flashing tool or the command line ( sunxi-fel ) to write the new .bin file to the device. A full flash typically takes about 45 seconds . The device may enter a boot loop that