General Tolerance Iso 2768-mk Link

: The standard does not account for material properties or the specific manufacturing process, which can influence the achievable tolerances.

For a nominal size between 6mm and 30mm, the ‘m’ tolerance is ±0.2mm . For 120mm to 400mm, it is ±0.5mm . general tolerance iso 2768-mk

Section C — Drawing interpretation and correction (20 marks) 10. (8) A drawing note reads “Tolerances: ISO 2768‑m”. The drawing also shows a critical hole Ø12 H7 (H7 tolerance explicitly shown). Explain which tolerance controls the hole and why. If the hole callout is Ø12 H7 with no additional notes, give the rationale whether ISO 2768 affects it. 11. (6) On an assembly drawing, a set of mating parts are dimensioned: shaft nominal Ø20 (no tolerance), mating bore nominal Ø20 (no tolerance); note reads ISO 2768‑mk. Is this acceptable for precision fit? Explain what the drawing should show to ensure a clearance fit of 0.02–0.05 mm. 12. (6) A supplier manufactured a part to k class tolerances though the drawing specified m class; the part’s critical dimension of 25 mm is out of tolerance for m but within k. Explain the likely consequences for assembly and recommended actions (3 points). : The standard does not account for material