| Issue | Symptom | Root Cause | | |-------|---------|------------|--------------------| | No IP assigned | Devices stuck on “Obtaining IP address” | DHCP server for guest network crashes or conflicts with main DHCP range. | Static IP Range: Set Guest DHCP range outside main pool. Main: 192.168.31.100–200 Guest: 192.168.33.50–150 (different subnet) | | Guest sees main LAN devices | Security breach | AP isolation disabled or incorrect VLAN tagging. | Enable AP Isolation: In Guest Wi-Fi settings, check “Allow guests to access each other” → NO . “Allow guests to access local network” → NO . | | Slow / intermittent speed | High latency, packet loss | Co-channel interference with main 2.4 GHz network. | Fixed Channel: Set main Wi-Fi to channel 1,6,11 (e.g., ch6). Set Guest Wi-Fi to same channel (AX1800 forces same radio). Reduce beacon interval to 100ms. | | Clients disconnect every 30 min | Logout loop | Default DHCP lease time too short (2 hours). | Increase Lease Time: Via SSH or config file → Set dhcp_lease_time=86400 (24 hours). Not exposed in GUI – requires advanced access. | | No internet for guests | DNS failure | Router’s DNS proxy doesn’t forward guest subnet. | Manual DNS: In Guest settings, set Primary DNS 8.8.8.8 , Secondary 1.1.1.1 . Disable “Use same DNS as main network”. |
: Select the Toolbox tab at the bottom, then tap More if "Guest Wi-Fi" is not immediately visible. create guest network on xiaomi mi router ax1800 fixed
: If you don't see the Guest Network on your phone, wait 60 seconds for the router to broadcast the new signal. To help you optimize your network further, let me know: | Issue | Symptom | Root Cause |
To set up a guest network on your Xiaomi Mi Router AX1800, you can use either the or the Web interface . | Enable AP Isolation: In Guest Wi-Fi settings,